I tried printing something on my bambu instead of my voron since I cant get the voron working properly. Why do the outer walls do this?

  • stealth_cookiesEnglish
    2·
    3 days ago

    That the default petg profile? Bump up your temperature by 10C and try again. Their PETG profile is too cold for the flow rate.

      • stealth_cookiesEnglish
        3·
        3 days ago

        Wrong way to adjust, try printing at 265 and keep the part fan on ( aux fan off).

          • stealth_cookiesEnglish
            3·
            3 days ago

            Run a temp tower if you are worried about it, but I run all PETG at 265 on my P1S. 255 will tear like you show and print matte which means it isn’t properly melted.

  • SpikesOtherDog@ani.socialEnglish
    2·
    3 days ago

    If I have to guess, it looks like compression. Either you are over extruding or your print head is too close.